Initially, setting up Vyper (an experimental language, with python-like syntax, for writing smart contracts on ethereum) seemed as simple as following the instructions.
If you like to skip the details/troubleshooting, head over to TL;DR
I’ve written about why I prefer pyenv earlier
I’m not sure whether my “misfortune” was due to pyenv, but it could be.
To top it off, I also used
virtualenv as suggested in the official docs. (I
would have done that any way)
So it added to complications, and “simple” instructions did not work.
I had discussion on gitter about this issue, and one person had also faced
problems. (But he wasn’t using
Problems and Solutions
It seemed that missing
requirements.txt is the problem (and the in-progress documentation)
Several dependencies are not clearly listed.
First I ran into the following error, but the solution is well documented.
So I had to set the
LDFLAGS variable, as mentioned on the official instructions page.
While troubleshooting, I realized that dependencies are badly broken.
I manually installed
py-evm because it is listed in setup.py
This installed a whole lot of packages correctly which are required later.
troubleshooting guide, asks to install a specific version of
When I did that, I saw several errors of the nature
packageA requires pakcageB,
which is not installed. Yet, at the end I saw
That does not make sense.
pip install py-evm I think installed whole lot of those missing packages
(Note: In my latest attempt to verify these instructions,
make worked after this)
Then I ran into error related to
Essentially it was trying to download pytest-runner, so first I tried curl using that URL (minus #sha256..) it worked. It dumped binary on the console. So there was no error reaching and downloading the file. So I manually pip install pytest-runner==4.2 After which make worked. (make test still failing, because I’m getting same error, but for ethereum)
I think it may have been “one off” error, cause in later attempts, I did not face this issue.
TL;DR : Steps that worked
As mentioned in the official documentation I already
had python 3.6 and
gmp installed via
Note : In the steps above, I’ve listed a specific versions of various packages I installed manually. Eventually, It was not required. So try without mentioning specific version at first. If that does not lead to success, maybe try specific version - which may differ depending on when you are reading this